HOW TO DISCONNECT/REMOVE TORS ON BANSHEE:

1. Unplug the wires coming out of the TORS carb caps.

2. Follow those wires back to the wiring harness and cut the plugs off as close as you can and put a piece of small heat shrink tubing over the end of each wire and shrink it. then tape them into the harness.

3. Unplug the TORS brain box. It’s a small black box on the left side of the frame under the gas tank. Then follow those wires back and cut them off and heat shrink them.

4. Take the throttle cover off and remove the small switch in there and then unplug it. Follow wires back... (Heat shrink and cut like previous steps.)

5. Buy a new clutch perch and lever the stocker is junk. Also remove the parking brake while you’re at it and get a block off plate. Then unplug the wire coming out of the clutch perch and follow those wires back and heat shrink and cut like before.

6. Buy a TORS removal kit from Vito's performance or Toomey or Alba. Then remove your old crappy junk TORS caps on the carbs and install the kit!

7. Most important step! Step back admire your work and sip at a beer. Pour something flammable on the pile of junk you just hauled off and watch it burn! But cut off all the plugs first. Those could come in handy sometime...