NONVLSI TESTER NOTES

• Problem: LTX Multiplex
  • Put off TS88 type at terminal Ctrl+Alt+Delete then wait for the standalone command or display
  • Put on TS88 power
  • then load program
    
  • If device wont pass try calibrating on terminal:(small)--type 2 enter 4 enter 0 enter or if device is failing on O/S testing type 2 enter 3 enter 10 enter
  
  
• LTX TRAINING
  • CALIBRATIONS
    • LOAD BIT.CK(to check Data transmission)
    • LOAD TIMER.CK
    • LOAD MMCAL.CK(to check metrimax board)
    • LOAD NVICAL.CK(calibrate kelvin sources-board with force/sense voltage/current)
    • LOAD QVSCAL.CK(non kelvin)
    • LOAD NACAL.CK(Nanometer)
    • LOAD TFECAL.CK(timer rise time, front)
    • DEBUG (any program)
    • LOAD X4176D06(number on socket adapter)-use to diags socket adapter
    • L[F1]-to recycle test
    • S[F1}-to stop
    • LOAD DSPCAL.CK- use to diags waveform synthesizer/digitizer-just remove connectors at board at cardcage then plug-in the coded plug type WS-WD connector at socket A.
  
  
• BP PROGRAMMER
  • Power OFF procedure
    1. Programmer Power Off
    2. Motor Power Off
    3. Main Power Off
  • Power ON Procedure
    1. Main Power On
    2. Motor Power On
       • should be powerered on 3 seconds after main power is put on, if not Motor Error will appear on console
    3. Programmer power on
    
    
  • Configuration should be LPT2 and BP-2200
  • Jobmaster Password: STEP
  • Wait for green light at handler not yellow/red light
  • DC Voltage at Motor T, Z, Y, X should be 1, 1, 2.7, 2.7 volts to operate if not adjust by turning trim pot at board
  • Selector A is for BP while B is for Handler, to change menu just press PAUSE/BREAK until led(3 green LEDS on keyboard) is lit for a while