The boar I got the mold from my uncle who is a taxidermist. I took a copule of deer antlers and put into the mold after I turned them around so that they would face forward.

I put some LED eyes in it and brought the wires out into its mouth, all I would have to do was pull the bottom set of teeth out to put the battiers in the eyes and the battier would hide under the bottom set of teeth.Then I put a set of clear eyes in the boar.

After I got the boar done I took two L brackets and mounted the brackets to the tracks and to the back of the boar.I also mounted a bracket to the back of the boar for the air ram to hook to.

The air ram was a door cylinder with the screw removed from the end of it, here I opoxyed a fitting that I could screw on a 1/4" fitting with the air hose hooked to it this air hose was 1/4" icemaker hose so the biggest part of my fittings were 1/4", The air hose came out of the air ram to a tee at the tee there was a bleed off(this is a piece of 1/4 brass tube with the end just about closed shut)the other end of the tee went to a needle valve that you use to control the flow presser of the air,then the air hose goes to a fitting at the end of a piece of 1/2" air hose that is hooked to the washing machine solenoid (hot and cold water solenoid off any washing machine,can even get these at about any washing machine repair shop, you can even use used ones)make sure that you clamp this 1/2" hose on both ends. Now on the other side you will have to go to hardware store and get fittings to reduce the air line to where the water hooks on the solenoid.