Part  2 of 3

WIRING A 4-WIRE DREAMCAST MOD CHIP

WIRING THE CHIP:

If your DreamChip is pre-wired click HERE to bypass the chip wiring section.

Step 1
Locate the 5 pre-cut, pre-stripped, pre-tinned, color coded wires from your package.
Red, black, green, yellow and violet. If you received 6 wires  (red, black, green, yellow, orange and blue) then you received a 6 wire modchip. If you recieved 5 wires then you recieved the 4 wire modchip. The 5th wire is used as a bridge only.

Step 2
Connect the 5 color coded wires to the bottom of the DreamChip using the included solder. Attach 2 wires to the bottom corners of the chip and 2 power wires in the middle. Then use the Violet wire to bridge the two points on the chip. See below for wiring diagrams. You might find it easier to wire the chip up from the backside as the pins loop around the back. Be careful not to bridge any of the pins when soldering. 

View of chip before bending back points	View of chip after bending back points

View of top of chip

View of chip before bending back points	View of chip after bending back points

View of back of chip

Click HERE to continue

" PlayStation"  is a registered trademark of Sony Computer Entertainment and "Dreamcast" is a trademark of Sega Corp. to which we have no affiliations. Our company is not affiliated with Sony or Sega in any way. The modifications, MOD chips, Stealth Game Enhance or any other item's listed on this web site was not produced, manufactured or endorsed by Sony Corp., Sega Corp. nor any of its affiliates or representatives, therefore they hold no responsibility for the use of this modification with their product.