Motor Template for T-52
This template should be printed out so the inch marks measure one inch - also, this template can be used when either mounting a Speed 400 motor, or a "600" size motor, either when using direct drive or some reduction drive units.
Print out the template, and gather the following items:
After marking the fuselage doublers with the template,
make the cuts as shown:
OPTIONAL: Using a small screwdriver, open each
hole where the tie-wrap will go through.
Open the hole in the same direction the tie-wrap
will be threaded through the fuselage doubler.
This will make threading the tie wraps a
little bit easier.
Here's the finished installation, from the top view:
