| Previous | Toc | Next |
Figure 24
Approximate Flat Rate Time 1 hour.
SEAT COVERS
Procedure
for Installation of
All Types of Seat Covers on
Two-Door, Bel Air and Convertible
(Fiber - Plastic - Rayon)
1.
Remove rear seat cushion and back rest
from car.
REAR SEAT BACK
1. On
deluxe models remove top trim rail from
back rest. NOTE: "Special" models not
equipped with trim rail.
2_
Place seat cover on back rest and line up
seams with contour of back rest, hog ring
as shown in Figure 25.
3.
On deluxe models replace trim rail and re
install back rest in car.
REAR SEAT CUSHION
1. Place
seat cover over seat cushion and line
up seams and floor tunnel "cutout," hog
ring as shown in Figure 26.
Figure 26
2. Replace rear seat cushion in car.
FRONT
SEAT BACK REST
1. Remove robe cord as shown in Figure 27.
Figure 27
2.
Place seat cover over back rest and work
down evenly, about two inches on each side
Figure 25
Figure 28
| Previous | Toc | Next |
