| Previous | Toc | Next |
2.
Line up seat cover to contour of cushion,
afd hog ring front edge as shown in Figure
35.
3.
Pull seat cover down under bottom edge of
side panels and install spring clips as shown
in Figure 34.
Figure 35
4.
Cut back out of seat cover, as shown in
Figure 34.
Figure 37
5. Place
seat cover over back rest and line up
seams with contour
of back rest and hog
ring as shown in Figure 39.
Approximate Flat Rate Time 1 hour.
SEAT COVERS
Exposabilt
Installation of
Front Seat Only
(Fiber - Plastic - Rayon)
FOUR-DOOR FRONT SEAT
1.
Remove seat adjuster knob and side panels
froze seat assembly.
2.
Remove four cap screws from each side of
seat assembly which hold seat to floor pan
of body and remove . front seat assembly
from car.
3.
Remove the three sheet metal screws
lo
cated at the bottom rear edge of back rest
as shown in Figure 36. Remove back panel
by pushing down on back panel.
5a.
Place two 24 inch wires in rear edge of
front seat cover and fasten with "S" hooks
as outlined on page
10, figure 22.
6.
Place seat cover
on seat cushion and line
up seams with contour of cushion and hog
ring as shown in Figure 38.
Figure 38
Figure 36
| Previous | Toc | Next |
