FRONT

REAR

1. Remove two end bolts and attaching parts
from bumper face bar.

2. Place fender guard in position by inserting
bolt at section A-A in bumper face bar and
aligning hole at Section S-S. Insert bolt
furnished with unit and replace other attach
ing parts as shown in figure 67.

3.   Left-hand fender guard shown. Attach right
hand fender guard in same manner.

4. If top rear portion of fender guard is closer
than 3/4 inch to the fender, add washers
between bumper rear outer bar and bumper
face bar to maintain that clearance.

Figure 66-A

1. Remove two end bolts and attaching parts
from rear bumper face bar end.

2. Place rear fender guard assembly in posi
tion, aligning holes, insert bolts and attach
ing parts in the same order that they were
removed. (See figure 68.)

3. Left-hand fender guard shown, attach right
hand rear fender guard in the same manner.

Approximate Flat Rate Time .5 of an hour.