from which the regular parts were   removed.
(See figure 109.)

Tighten attaching screw securely.

Approximate Flat Rate Time .1 of an hour.

986523 DUAL FOG LAMPS

Procedure for Installation of Dual Fog Lamps
on All Model Passenger Cars_

Figure 111

1. To locate 1-1/2 inch holes in the filler pan
el, assemble inner and outer clamps to the
bumper support bars as shown in figure 112,

2.

3.

4.

5.

outer clamp should be located 7/8 of an
inch from the bend in the bumper support
bar as shown in figure 113. Insert lamp
mounting brackets thru the inner and outer
clamps until brackets touch filler panel.
Mark circle around brackets on filler panel,
then remove brackets and clamps. Locate
center of circles and drill 1/4 inch holes
in filler panel, With 1-1/2 inch hole. saw
use 1/4 inch holes for guide in cutting the
1-1/2 inch holes in filler panel.

Reassemble the inner and outer clamps to
the bumper support bars loosely and insert
lamp mounting brackets from top side of
filler panel into the inner and outer clamps.
Adjust lamp mounting brackets so as to have
2-17/ 32 inches clearance from bumper
guards as shown in figure 112, insert rubber
grommet in filler panel and tighten clamps
securely.

Assemble fog lamps to brackets loosely, us
ing the washers and nut as shown in figure

112

Place right-hand fog lamp wire thru clip on
fender skirt and around radiator tie bar to
left-hand side of car as shown in f igure 113.
Place left-hand fog lamp wire thru clip on
fender skirt and grommet in front fender
skirt as shown in figure 113, left-hand fog
lamp wire to follow the car wiring harness
thru grommet in dash into passenger com
partment.

Figure 112