| Previous | Toc | Next |
steering
post and adjust up or down
until
switch lever turns easily to "on" position
while rubber roller is under slight compres
sion as shown in figure 186.
same
terminals on junction blocks
from
which others were removed. Connect
other
wires to those brought forward
from turn
signal switch with connectors
furnished in
Figure 182
2.
Remove car wiring harness grommet and
rework as shown in figure 182 using a round
file or other satisfactory tool. Replace
grommet with turn signal wiring harness in
therein.
3.
Pass harness along left side of motor com
partment to radiator, securing to existing
car harness with clamps supplied, as
shown
in figure 182. The longer of
the two wires
from turn signal should be carried across
for the right--hand parking lamp, attaching
with clips to the radiator tie bar, (see fig
ure
187)_
4.
Remove parking
lamp bulbs, sockets and
wires,
and
replace with those furnished in
package
as shown in figure 183. Connect new
parking
lamp wires with spade terminal to
package.
5.
Install clip on dash leg as shown
in figure
183. Run long wire from turn signal down
under floor of car and along frame on left
side of car using 6 spring clips furnished
in package, locate rubber plug in luggage
compartment floor behind composition wall
at left side of compartment.
Remove this
plug and replace with grommet supplied in
package. Run the wire through this grom
met and connect to left-hand stop lamp as
shown in figure 184.
6.
Disassemble natural with black and green
cross tracer wire from
connector (located
in upper left corner back of instrument pan
el). Connect natural wire from turn signal
Figure 183
| Previous | Toc | Next |
