See figures 192 and 193 for "A" and "H"
locations. After locating lamp positions drill
7/16 inch hole on crown of fenders. Place
wire of each lamp through fender and install
the flat washer, lockwasher and nut and
tighten lamps securely. The right-hand lamp
wire should be taped to reinforcement plate
of the fender as shown in figure 195. Pass
the wire through the existing headlamp grom
met in fender skirt and clip to radiator tie

bar as shown in figure 193, Tape the left
hand wire to reinforcement plate and through
existing headlamp grommet and run the left
and right-hand wires along existing wiring
harness to the three way connectors and
clip to wiring harness as shown in figure
193.

4. Place rear lamp wires in three way con
nectors and follow truck wiring along frame
to rear lamps.

5,   Rear lamp mountings will vary with the type
body used on the truck. Instructions for the
most popular body types are shown in the
following figures:

Pick-up body figure 197.
Panel body figure 200.
Platform body figure 198.
Cab and Chassis figure 19 19.

Approximate Flat Rate Time 1.3 hours.