| Previous | Toc | Next |
Procedure
for Installation of Ventshades
on All Model Passenger Cars.
1.
Ventshades will fit only the models shown
on the carton label.
2.
Ventshades are stamped to show their posi
tion - RF for right front door; LR for left
rear, etc.
3.
Insert flange between the weatherstrip and
vent wing division post. Then work the flange
up between the weatherstrip and reveal
moulding, flange should disappear and curves
fit properly. (If weatherstrip bead overlaps
the vent wing division post, clip off over
lapping portion.)
Figure 204
4.
Center punch and drill the front screw hole,
using a 3/32 inch drill. Drill through re
veal moulding and door frame as shown in
figure 244. Insert self-tapping screw.
5.
Holding shade in position, center punch and
drill remaining hole and insert self-tapping
screw.
6. Run
window glass up, if window binds spread
glass channel to allow complete closing.
NOTE: Installation procedure
is the same
for all styles and body models.
Approximate Flat Rate Time .3 of an hour.
986433 OUTSIDE CAR VISOR - METAL
Procedure
for Installation of Outside Car Visor
on All Model Passenger Cars,
except Bel Air and Convertible
Figure 205
1.
Prepare visor for painting by thoroughly
cleaning with a naptha dampened cloth, allow
sufficient time to dry. It is not necessary
to apply another primer coat before painting
to match color of car. Mask out underside
surfaces and stainless steel leading edge
trim, before spraying. Paint only the top
surfaces of the visor.
2.
Align center support in proper position be
tween both visor body sections and fasten all
three members together with three screws,
lockwashers and nuts as shown in figure 246.
Figure 206
3.
Assemble center clamps to center support
as shown in figure 206, by inserting two
screws into adjusting slots with washers and
nuts, then insert two clamping screws to
clamps with washers and nuts. (DO NOT
TIGHTEN NUTS.) Allow sufficient width be
tween jaws to pass over
moulding.
4. Place
curved edge
of medallion around lead
ing edge of visor
and draw tightly
over rear
edge of visor. Insert screw through hole in
medallion and visor and fasten securely as
shown in figure 207.
Figure 243
| Previous | Toc | Next |
