Figure 18 Figure 17 Redrawn Showing Some Value Changes and Current Sink as an M O S F E T. The hot input terminal goes through a 0.1 u f capacitor to the grid of a triode. The grid also connects to a 100 k ohm resistor. The other end of the resistor connects to a point labeled capitol e small cc. The grid goes to the grid of the second triode through a 1 meg ohm resistor. The grid of the second triode goes to ground through a 0.1 u f capacitor. The cathodes of the two triodes are tied together and go through a 6.8 k ohm resistor to the drain of an m o s f e t which is labeled IXCP10M45S. The source of the m o s f e t goes through a 330 ohm resistor to ground. The gate goes through a 1 k ohm resistor to ground. The plate of the first triode goes to one end of a resistor. The plate of the second triode goes to one end of another resistor. Both resistors are labeled 33 k ohms. The other ends of both resistors go to a point labeled capitol e small bb. The plate of the first triode goes through a 0.1 u f capacitor to output 1. The plate of the second triode goes through a 0.1 u f capacitor to output 2. There are 100 k ohm resistors connected from each output to ground. This completes the description of figure 18.
Go Back