[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PROTEL EDA USERS]: Drill Drawing
In a message dated 9/27/00 11:33:39 AM Eastern Daylight Time,
hans2@seas.upenn.edu writes:
> I managed t0o get the Drill File out and load it on camtastic ...
> however, gerber and NC are not aligned. Why did this happen? I didn't see
> an offset option on Protel and I reset the origin before generating files.
>
Never, ever, turn on the "center plots on film" option when generating
Gerbers.
Steve Hendrix
