Mounting and Guying
1. After selection of a safe position of the mount, position anchor points for the guy wire as shown in figure 1.
- 2. Attach guy wire (4 places recomended) to the lowest guy ring and wrap wire at least 6 turns around itself, see figure 2.
- 3. Insert lower section of Telescoping Mast into mount,making sure the mast is in vertical position, and insure the guy wires at the anchor points.
- 4. After the guy wires have been secured for the lower section, a ladder may be leaned against the mast and tied in place.
- 5. Mount your antenna to the upper mast section, (1-¼ Dia.) and secure transmission line with standouts.
- 6. Raise the upper section of the mast with the antenna until it reaches its stop. Tighten clamp with hex bolt to secure upper section in place.
- 7. Using a person at each anchor point to hold guy wires, raise each section and secure in place as indicated in step 6. (working from the smallest dia.(1-¼) to the largest.)
- 8. After Telescoping Mast is fully extended, draw the guy wires taut (keeping the mast perfectly vertical) and secure to anchor points.
To know more about the masts, click ahead
![](https://www.angelfire.com/fl4/TelescopicMasts4/arrow44l.gif)
![](https://www.angelfire.com/fl4/TelescopicMasts4/arrow44r.gif)
CB
Radio Banner Exchange