.
VITEK PERFORMANCE
IGNITION WIRES
VITEK Performance Cables have our unique stainless steel wire wound ("Mag Wire") conductor with a Dupont Kevlarâ core. The conductor is insulated with an extrusion of gold silicone then braided with Fiberglass to achieve ultimate mechanical strength of the finished product. The wire goes through a second extrusion of pure black silicone to a finished diameter of 5mm, 7mm or 8mm depending on the original equipment requirements. It should be noted that this construction has better dielectric properties and capacitance than the 8.5mm wires used by some competitors as a marketing gimmick. Over size wires often won't fit the original looms making routing a problem as well as not providing the proper fit for the boots and terminals; In short they offer no advantage and many disadvantages.
WIRE BRAID KITS
Take the heat off of your under hood lines and hoses by installing VITEK’s premium braid kit!! The braid covering withstands up to 1200F and looks great by adding color to your engine compartment. It is available in 8 colors, red, yellow, blue, green, purple, black, white, and silver. The kit comes with 4 different sizes to cover all of your under hood hoses and wiring. It is complete with all necessary hardware to install.
AXELS
Vitek shafts are designed for racing and are made to withstand extreme abuse. The Cro-Moly axle shaft is 30% larger in diameter than any other replacement drive shaft on the market. Longer axle splines make for better gripping and the in-board joint has 6 points of contact instead of 3. These are new shafts, not remanufactured. All Vitek half shafts are ABS ready for the track or the street
CLUTCHES
VITEK Performance Products is pleased to announce our new VITEK Performance Clutch. The clutches are designed to hold all of the power your engine can dish out and ensure that the power makes it to the asphalt. They are available for all domestic and import vehicles. Specific applications are available for street, street/race or race only. As with all other VITEK products, these clutches are premium quality and far exceed OE standards.
RADIUS ROD BEARINGS
These bearings locate the radius rod in the front crossmember. Installing the Vitek radius rod bearing and removing the factory rubber bushings eliminates all of the play associated with rubber bushings. This greatly improves the cars handling and ride. With the installation the car is now able to have the caster easily adjusted.
LIMITED SLIP DIFFERENTIALS
It's the lead drivers secret advantage. Eliminates wheel spinning on take-off and cornering. Easy to install and requires no machining. They are designed and built from original stock, so fit is not a problem. Now you can even race in the rain, snow or ice. Available for most front wheel drive applications.
Vitek Performance
Navigation
