| The Super Squeegee is a barrel cleaner that you would use between games that thoroughly cleans your paintgun barrel including any porting!!! None of the commercial squeegees I have used can accomplish that! |
|
Materials Necessary :
Tools (may need more, may need less) : |
| Construction : | ||
|
|
Cut 2 inch PVC to a length of 13 inches. |
|
|
|
Cut dowel rod to 12 inches |
|
|
|
Drill a 2 inch deel hole in one end of the dowel rod. |
|
|
|
Drill 2 holes through the side of the opposite end of the dowel rod 1 inch apart. |
|
|
|
Drill a hole in the top of both PVC caps. |
|
|
|
Take some yarn and wrap it around the dowel rod between the holes in drilled in the side of the dowel rod. Then run 1 -2 loops of yarn around the wrapped yarn perpendicular to the direction the wraps run through the holes. |
|
|
|
Using the wood screw, attach the dowel rod to a PVC end cap. Then seal it with the caulk inside. |
|
|
|
Cement the PVC cap to the 12 inch PVC section. |
|
|
|
Drill a hole 1½ inches from the open end of the PVC section and fasten a screw and wing nut in that place. Also put a screw and wing nut on the other PVC cap. |
|
|
|
Tie a loop in each end of a piece of twine and slip the loops under the wing nuts and tighten. Seal the inside of the PVC cap and PVC pipe section with caulk. |
|
|
|
||
Instruction For Use :
Fill the SuperSqueegee with water that has a little dish detergent in it. After games remove the barrel of your gun and use the dowel rod inside to clean it. The PVC cap with the wing nut is for closing the squeegee to keep the water inside. After you clean your barrel, run a commercial squeegee, paper towel or Kleenex through it to dry the water out. I know this seems like a waste of time, but it completely cleans your barrel of paint including any ports or suppressor. |
