DX 99VFrequency Counter (with "ON/OFF" switch)
Variable Dimmer Control for Meter Lamp, Frequency Display and Channel Readout
Large Meter with Scales for Signal Strength and Power Output
Meter glows Red during Transmit
Roger Beep (with "ON/OFF" switch)
Noise Blanker/ Automatic Noise Limiter
+10 KHz Switch
SSB in addition to AM/FM/PA
PA Features:
Echo Board with Dual Control
Voice Changer with Pitch Control
Robot Sound (one-position)
Talk Back "ON" during Echo, VC or Robot
Variable Power Output
10 Watts Maximum Power Output - AM
25 Watts Maximum Power Output - SSB
1.5 KHz Clarifier for Receive Only
5.0 KHz Clarifier for Receive and Transmit
TWO YEAR Limited Parts and Labor Warranty
![](/magic2/cbguys/95T.jpg)
A High-Performance output circuit that uses two Toshiba 2SC2290 power transistors to generate 50 watts for AM/FM and 150 watts for SSB operation
Chassis incorporates a solid aluminum finned rear section as a heatsink
Additional heat sink on the bottom of the radio with an internal Micro cooling fan increases the radio height from 2.5 to 3 inches
Same main circuit board as our DX 2517, DX 93T, DX 48T and DX 45MP
"StarLite" faceplate is matte black with all lettering backlit in green and blue
Switchable sixth digit provides five or six digit frequency display
Our exclusive "SuperSlider" circuit maximizes frequency control by switching the Fine clarifier between Receive/Transmit and Receive Only operation or completely out of the circuit with one slide switch. The Coarse clarifier operates on both receive and transmit unless the SuperSlider switch is off. When switched off, both clarifiers are out of the circuit.
Retro-look red modulation lamp (with On/Off switch) flickers like the old neon lamps of the Fifties and Sixties
Front mic jack
Variable power output control
Red channel and frequency digits
Heavy duty DC power cord
Strange and Unusual Features:
The echo has internal controls only. It is our famous dual control echo circuit without any controls on the front panel. The On/Off switch is there, but to adjust the echo sound, the bottom cover must be removed. Locate the rectangular metal box containing the echo board. Do not open this box. Use a small plastic tuning tool to gently adjust the trimmer pots inside the holes marked "ECHO" and "TIME." These pots are somewhat fragile so it is best not to use a metal screwdriver.
A single slide switch controls both the Echo and the Roger Beep. They can both be off, but they cannot both be on at the same time.
There is no receive gain pot. A 40dB attenuator switch takes its place.
The DX 95T also has the following standard features found on most other Galaxy radios :
Large, easy-to-read meter with 4 scales:
"S" meter indicates up to 60dB over S9
Modulation percentage scale for use on AM
Calibrated power scale
SWR scale
Automatic SWR circuit (No complicated calibration procedure required)
LED's light red to warn of high SWR
Talkback circuit with On/Off switch and volume control
Variable dimmer control pot
On/Off switch for frequency display
Roger Beep circuit
NB/ANL circuit
Meter glows red during transmit
Two year limited warranty
DX93T
![](/magic2/cbguys/93T.gif)
A High Performance output circuit that uses one Toshiba 2SC2290 power transistor to generate 20 watts for AM/FM and 50 watts for SSB operation
Dual Mini cooling fans on the rear increase the overall radio length by only one half inch
New chassis incorporates a solid aluminum finned rear section as a heatsink
Main circuit board upgraded to the same board as the DX 2517 base radio
New "StarLite" faceplate is matte black with all lettering backlit in green and blue
Retro-look red modulation lamp flickers like the old neon lamps of the Fifties and Sixties
Our exclusive "SuperSlider" circuit maximizes frequency control by switching the Fine clarifier between Receive/Transmit and Receive Only operation or completely out of the circuit with one slide switch. The Coarse clarifier operates on both receive and transmit unless the SuperSlider switch is off. When switched off, both clarifiers are out of the circuit.
Switchable sixth digit provides five or six digit frequency display
Red channel and frequency digits
Front mic jack
Heavy duty DC power cord
Out with the old:
A three-position power level switch takes the place of a variable output pot
A 40dB attenuator switch takes the place of a receive gain pot
A dim switch takes the place of a dimmer pot
No On/Off switch for the frequency display
No Roger Beep circuit
The DX 93T also has the following standard features found on other Galaxy radios:
Large, easy-to-read meter with 4 scales:
"S" meter indicates up to 60dB over S9
Modulation percentage scale for use on AM
Calibrated power scale
SWR scale
Automatic SWR circuit (No complicated calibration procedure required)
LED's light red to warn of high SWR
Echo with dual controls
Talkback circuit with On/Off switch and volume control
Meter glows red during transmit
NB/ANL circuit with green LED indicator
Two year limited warranty
DX48T
![](/magic2/cbguys/48T.gif)
A High Performance output circuit that uses two Toshiba 2SC2290 power transistors to generate 50 watts for AM and FM operation (No SSB operation)
New chassis incorporates a solid aluminum finned rear section as a heatsink
Additional heatsink on the bottom of the radio with an internal Micro cooling fan increases the radio height from 2.5 to 3 inches
New "StarLite" faceplate is matte black with all lettering backlit in green and blue
Main circuit board upgraded to the same board as the DX 2517 base radio
Front mic jack
Heavy duty DC power cord
Items NOT included:
No frequency counter
No jack for accessory frequency counter
No Roger Beep circuit
No clarifier
Three-position dimmer switch takes the place of a variable dimmer pot
The DX 48T also has the following standard features found on other Galaxy radios:
Large, easy-to-read meter with 4 scales:
"S" meter indicates up to 60dB over S9
Modulation percentage scale for use on AM
Calibrated power scale
SWR scale
Automatic SWR circuit (No complicated calibration procedure required)
LED lights red to warn of high SWR
Variable power output control
Echo with dual controls
Talkback circuit with On/Off switch and volume control
Green/Red LED indicator for Receive/Transmit
NB/ANL circuit
Receive gain control
Two year limited warranty
DX45MP