Site hosted by Angelfire.com: Build your free website today!
Rubik's Cube Solution


In this section of my website you will find all you the necessary
information needed to solve the Rubik's Cube.


STEP ONE
Legend



R = Clockwise turn of right face

R' = Counterclockwise turn of right face

R'' = Half turn of right face

The first step is to get the cube looking like this: You need to be able to view the pictures


First pick a color to be on the DOWN face. This will remain down for the entire process. In my diagrams, I have chosen the color white, but you are welcome to pick a different color. What you need to do is get the 4 bottom edge pieces matched up with the center of the DOWN face, as well as with the other center pieces as in the above picture. In other words get the cube looking like the picture above, not like this:

If you are lucky, one of the edge pieces is already in the correct place. All you have to do is turn the DOWN face (D) until the colors on the edge piece match the center piece on the bottom and the center piece on the side.


Now, there are 4 possible wrong places where an edge piece can be. It can be in the top layer in two positions, in the middle layer, or in the bottom layer. If it's in the top, rotate the UP face a few times until the side colors match like in the figure. Remember white is the bottom color.

If it's like the left diagram, then you will need to do this move: F'' (That means turn the front face a half turn). If you don't understand this terminology, go back to my Terms To Know page.

If it's like the right picture then you need to do this move: U'R'FR (Turn the UP face counterclockwise, then the RIGHT face counterclockwise, then the FRONT face clockwise, and then the RIGHT face clockwise)


Notice that the piece in the top layer moved into the purple spot.


Now, let's say that the edge piece is in the middle layer:

All you have to do is F'U'F to get the piece in the UP layer. Now, it's in the UP layer and you just learned how to do that.


What if the edge piece is in the bottom layer but in the wrong place:

Here, do the turns F''U'F'' and then it is in the UP layer and you can do that already.

That wasn't so hard was it?

Onward to Step 2

"It would take me forever to solve one of those." - Anon.




Email: jamber_15@hotmail.com

Cause Marijuana is bad Mmkay?
Copyright © 1998-2014 All Rights Reserved.
Welcome To My World® is a registered trademark.

Personal | Elvis Presley | Melanie C | Jose Canseco | Liverpool FC | Shawn Antoski | Vancouver Canucks | Quotes | Contact