Wetbike Motor Pull
undefined
undefined
These are the nuts you need to remove from the jet pump in order to pull the motor. (Should be eight studs)
In order to pull the motor I conjured up a harness using two tie straps. A cherry picker is probably the preferred method.
I then attached the harness to my garage rafters.
With a little negotiation (standing on the ski and pulling up on the hull - maybe a couple taps with a rubber mallet) the hull should seperate. At this point you should be able to pull the ski and jetpump out from underneath the wetbike.
You can now start racheting up on the motor and carefully make sure nothing is catching as it goes up.
At this point you will want to make sure the fuel line is disconnected.
You will want to also remove the throttle cable from the carb.
I then finished racheting up the motor and lowered with a car jack.
Back to Redneck Yacht Club
