Todd's 66 Chevelle Engine Bay
(updated 5/22/00)
This page is under construction
Todd pulling the 327.
The 327 reinstalled. Todd painted the block and heads with Eastwoods Header Paint. The motor is getting its share of polished stainless and chromed parts as well. The intake and water pump will be polished aluminum units.
The intake, waterpump, fuel pump, hard vaccume lines, and alternator have all been polished out. Todd and Andy made custom polished aluminum brackets for the power steering pump and alternator. They are extrememly trick units.
This is a close-up of the alternator bracket. These brackets were not bought, they were made out of aluminum stock!
The exhaust has been finished. Jet Hot coated headers running into 3", mandrel bent aluminized pipes dumping into 3" Flowmasters and exit out the rear. All stainless hangers and clamps.
These are pics of the 3" mandrel bent Tube Tech pipes. These pipes are HUGE! The middle pic is the crossover, or "H" pipe installed. Sorry about the third picture. That was supposed to be the collectors.
66 Chevelle Home
66 Chevelle Bodywork
66 Chevelle Trunk and Floorpan
66 Chevelle Interior
Rhea's Rad Rodding Page
|
