Our STANDARD Design Service gives you a completed Schematic Design in 5 weeks.
Size of Home * |
Cost per Square Foot of Covered Area |
|---|---|
| Up to 2,999 sq. ft. | $ 0.55 |
3,000 to 4,999 sq. ft. |
$ 0.45 |
| 5,000 sq. ft. and Above | $ 0.35 |
Our EXPRESS Design Service gives you a completed Schematic Design in 2 weeks.
Size of Home * |
Cost per Square Foot of Covered Area |
|---|---|
| Up to 2,999 sq. ft. | $ 1.05 |
3,000 to 4,999 sq. ft. |
$ 0.95 |
| 5,000 sq. ft. and Above | $ 0.85 |
*The per square foot cost of designing a smaller house is higher due to the increased effort necessary to create an efficient design in a constrained area.
After we have gone through two (2) major revisions and decide to make further major revisions, there will be a fee based on how extensive the revision is and how far we are along in producing the final plans and elevations. A major revision typically comprises of a more than 20% change in the design. There will never be additional charges and work done without the owner's written approval of this work. There are no charges for minor revisions as long as they occur before the creation of the Architectural Construction Drawings Set.
Change Requests will be charged at $75.00 per hour for design changes plus $40.00 per hour for computer-drafting.
Our STANDARD Design Service gives you a completed Architectural Construction Drawings Set in an estimated 8 weeks.
$1.50 per Square Foot of Covered Area
Our EXPRESS Design Service gives you a completed Architectural Construction Drawings Set in an estimated 3 weeks.
$2.50 per Square Foot of Covered Area
See Change Requests for revision scopes and fees.
For REMAINING 3 Elevations and Roof Plan Design (under Schematic Design).
$ 0.35 per Square Foot for Regular Lots $ 0.45 per Square Foot for Steep Sloping Lots / Irregular Lots
Creation of the 3 remaining Elevations is dependent on the shape of the lot the home will be built on. For this reason, an extra amount is charged for steep or irregular lots.
From 2-D AutoCAD files.
$600
From Hand-rendered sketches.
$1200
If such services are necessary, there is a fee for Structural Engineering computations and the signing of the plans by a licensed Structural Engineer registered in your State.
These fees are typically $ 0.45 to 0.55 through the Engineering Firm that we use.
Additional fees are charged for services required in some municipalities:
Fenestration Calculations - $75
RES Check Calculations - $75
2 sets of drawings are supplied at no cost. Additional sets are as follows:
11x17 - $ 0.15 per sheet
18x24 - $ 1.75 per sheet
24x36 - $ 3.00 per sheet
Click here for a free consultation on your new home ideas and an estimate on the approximate fees that could be expected.
Copyright 2005
Xtreem Designs
1017 Limeberry Court
Clayton, NC 27520
