To clear out the orange corner lights on the front u need some thin plexy glass,clear sealer, heat gun,dremel tool. ok remove the corner lights from the car, cut the plexy glass to the width and lenght of the corner lights( can be done in one or two pieces) once the plexy glass is cut to the length take the heat gun and heat the plaexy glass up till it is bendable( dont get the heat gun to close to the plexy glass cuz it will bubble if it gets to hot) once u can bend the plexy glass bend it over the orange corner lights. then take the dremel tool and cut off the orange lenses from the light socket take some silver paint and paint the plastic edge u just cut off. then make sure the clear lenses fit nice on the light socket(if not heat them up again and bend them so they do), when they fit corectly take the clear sealer and aply it to the edges and put the clear lenses on , wait for them to set and install them back on your car.
INTAKE
since the only intake made for the 3 gen prelude is a weapon R and this draws all the hot air from the engine bay i dont recomend getting it. so i did a little testing to see what intakes would fit my car and found out that the 2000 intake(has a 90 degree elbow) fits with a little bit of costomizing.
