How to get your foglights to work with your hi-beams. This is for the 95 to 97 J-body. Below this one will tell you how on the 98, I am working on how to do it on the 99's.

This is a simple step to do, and only requires a few minutes to do it.

1. Look up under the front bumper and between the radiator. In the middle of the car there are two relays. You need the relay on the passenger side of the car. In that relay is 4 wires, a black one, a blue one, an orange one and a pink one. Remove some of the electrical tape and cut the pink wire, make sure you cut it about 2 or more inches away from the relay just incase you want to redo the wire.

2. Now just tape the 2 ends of the pink wire up and re-tape all the wires back together and your foglights will work with you hi-beams.

This is how to get your fog lights to work with your hi-beams on the 98 J-body's.

1. Open the hood and look between the front bumper and radiator. There are two relays mounted (with plastic snaps) to the back of the bumper. The larger one located by the passenger side headlight controls the fog lamp operation when the high beams are on. The smaller one located toward the middle of the bumper controls the fog lamp operation when the low beams are on via the dash switch.

2. Pop the large relay on the passenger loose from the bumper and remove the electrical tape to access the wiring. The wires to be concerned with are one black and one green/white striped. Look at the bottom of the relay where the wires are entering and find the numbers stamped on the base. The pole "30" has a black wire. Cut this one (there are two so look carefully at the numbers on the relay).

3. Next cut the green/white stripe wire.

4. After this wire has been cut, tape off the end going into the large relay.

5. Next you will need to connect the remaining three ends together (two black and one green/white stripe) , I used a "butt connector".

6. Re-tape the wires, pop the relay back in place and that's it.