This is for all of you that have got the motor mount insert from RKSport or for those of you that will be getting one and want some help on how to put it in. Now it is all the same on what ever engine you have.

1. First step is to take the hose that hooks into the radiator fill bottle or over fill bottle what ever you want to call it that is closet to the fire wall off the bottle.

2. Then take out radiator fill bottle. There is one screw that is in the front part of the bottle remove it and lift the bottle up and out and swing it over to the front part of the car.

3. Now there are 4 nuts, 3 of them are on top of the steel part of the motor mount, but you can only see 2 of them at this time, and the 4 is down under where the radiator bottle was.

4. Remove the top 2 nuts and under the one that is closet to the fire wall there will be the 3rd one I was talking about, remove that one.

5. Now remove the one that is down where the radiator bottle would be.

Now you have the top part of the rubber motor mount showing.

6. There are 2 bolts that go into the top part of the rubber motor mount, remove them and remove the top rubber part of the motor mount.

7. Now the insert fits really tight so put some dish soap on it, make sure you put it all over it. Don't use WD40 cause the dish soap will just wash out with water and the WD40 will stay until it dissolves and that takes a lot more time.

8. Now push the insert in from the top as far as you can push it in.

9. This is where it fits really tight, there are a couple ways you can get it to go down all the way. One is use a rubber mallet and try tapping it down and the other one I think is the best is to put back on the part of the rubber motor mount and tighten the bolts back down. This will cause the insert to be push into place.

10. Now when you get that done put back on the steel part of the motor mount and put back in the radiator bottle. Make sure you put the hose back on the radiator bottle you took off and you are done. This should take about 15 minutes to do.