| Previous | Toc | Next |
5
a.
Natural red cross tracer wire to top
terminal on ignition switch. (See figure
5).
b.
Black tracer wire to one end terminal
on light switch. (See figure 5.)
4.
Figure 4 shows suggested connections of
various accessories.
Approximate Flat Rate Time .4 of an hour.
986526 ELECTRIC CLOCK
Procedure
for Installing Electric Clock
on Deluxe Model Passenger Cars.
1.
Remove clock furnished with vehicle by in
serting screw driver into slot in edge of
clock frame to left of setting knob and pry
ing until clock snaps free of retaining
springs, (see figure 7).
2.
Place lead wires attached to back of Elec
tric Clock through hole in clock housing and
assemble clock to housing. Make sure that
the spring clips on the sides of the clock
are aligned with slots in the housing and the
clock face is right side up, (see figure 7).
3.
Assemble wires in clips on back of instru
ment panel and connect the dial light lead
to the instrument light terminal on the light
switch (see figure 7) and the clock power
lead to the lower center terminal on the
battery side of the accessory junction block,
(see figure 8).
Approximate Flat Rate Time
Procedure
for Installing Electric Clock
on Special Model Passenger Cars.
1. Remove
nut and washers from two studs on
underside of clock hole cover plate. (Keep
these nuts and washers to reassemble clock
to instrument panel.)
| Previous | Toc | Next |
