| Previous | Toc | Next |
1. Remove
and discard dummy button or pres
ent lighter.
2.
Remove lamp socket from clamping shell
and clamping shell from lighter.
3.
Insert lighter
in instrument panel hole and
reassemble clamping shell and lamp socket.
4. Rotate clamp shell to position such that light
unit causes no interference.
5.
Route lamp wire through clips on back of
instrument panel. (See figure 134.) Attach
lamp wire terminal to tail lamp terminal on
light switch. (See figure 134.)
6.
Remove grommet from dash and rework
grommet by removing thin wall at end of
hole and cutting grommet from side to hole.
7.
Install wire from lighter through hole in
dash from which grommet was removed and
connect wire terminal to battery terminal
on starting motor solenoid being sure cigar
ette lighter wire is on top.
8.
Insert wire in grommet and
reinstall grom
met in hole in dash. (See figure 134.)
9.
To operate, push in knob which will return
to original position
when lighter is ready
for use.
Approximate Flat Rate Time .2 of an hour.
Figure 134
| Previous | Toc | Next |
