through hole in door. Fasten Bracket "B"
to door with oval head sheet metal screws.
AGAIN, care should be taken to tighten each
screw only a little at a time until both are
tight, thus keeping the Bracket from creep
ing and the Shaft from binding.

8. Slip Friction Bracket "J" over Shaft "F."
Use rubber spacer between Friction Brack
et and Door on convertible models only.

Remove string or rubber band from Racks.
9. Rotate Friction Bracket "J" to fit flat against
inside door moulding(see figure 169). Center

Figure 171