2. Insert drill bushing, furnished, into bracket
and tighten clamp screw to grip drill bush
ing.

3. Insert half inch drill through drill bushing
and bracket and drill half inch hole through
corner post as shown in fi~-,ure 175.
IMPORTANT: HOLD DRILL LEVEL. After
piercing the outer metal of corner post,
make sure that any wires or tubing inside
corner post are moved aside before drilling
through the inner metal wall.

4. Loosen clamping screw and remove drill
bushing from the bracket and discard bush
ing.

5_ Tighten the friction screw "C" in figure 176
and remove nut and wedge "D" and remove
handle from light shaft.

Figure 176

6. Insert the light through the outside bracket,
until the head housing is flush against the
outside bracket. The floating bushing on
light shaft should go into the recess of out
side corner bracket.

7. Place inside bracket over light shaft and
slide all the way on shaft, with arm up or
down to make best fit against instrument
panel or corner post as shown in figure 175.
The arm can be bent slightly if necessary.
Drill 1/8 inch hole and attach bracket with
self-tapping screw furnished. See "X" in
figure 176. Tighten bracket clamping screws
"C" to hold light assembly tightly in corner
post as shown in Figure 176.

B, Replace handle on light, being sure that the
head housing is pushed flush against the out
side bracket. Replace wedge "D" and nut.

9. Pass cable under bracket and run down close
to pillar and up under instrument panel.
Clip fuse holder to instrument panel flange.
Connect cable terminal to light switch at
lead from ammeter.

10, Head and Shaft Tension: Set screw "Y" ad
justs the horizontal or head friction, and

screw "X" adjusts the vertical or shaft fric
tion. Friction should be sufficient to hold
lamp in position against wind, but free enough
for easy operation.

Approximate Flat Rate Time 1 hour.

986418 ELECTRIC SHAVER

Procedure for Installation of Electric Shaver
on All Model Passenger Cars and Trucks.

Figure 177

1. Remove cigarette lighter element.
2. Plug adapter into cigarette lighter.
3.   Plug cord into other end of adapter and shave.
4. Remove adapter and replace cigarette lighter
element.

Approximate Flat Rate Time - NONE

986535 FRONT FENDER SHIELD

Procedure for Installation of Front Fender Shield
on All Model Passenger Cars.

Figure 178