RE: [PROTEL EDA USERS]: Default Designators

[Brad Velander <BVelander@norsat.com>]

Tony & Steve,
	just tried it on my install of P99SE SP5 and it works fine. My best
guess is that you may not have the "permanent" checkbox checked, therefore
the change was not saved for future component insertions? I don't know what
it could be other then that.

Sincerely,

Brad Velander
PCB Design Technologist
Norsat International Inc.
#100 - 4401 Still Creek Dr.,
Burnaby, B.C., Canada.
V5C6G9.
voice: (604) 292-9089 (direct line)
fax:    (604) 292-9010
email: bvelander@norsat.com
www: www.norsat.com


> -----Original Message-----
> From: TSListServer [mailto:owner-proteledausers@techservinc.com]On
> Behalf Of Tony Karavidas
> Sent: Friday, September 15, 2000 10:04 PM
> To: Multiple recipients of list proteledausers
> Subject: RE: [PROTEL EDA USERS]: Default Designators
> 
> 
> Seems like a bug. I just tried it and it doesn't work for me either.
> 
> 
> 
> > -----Original Message-----
> > From: TSListServer [mailto:owner-proteledausers@techservinc.com]On
> > Behalf Of HxEngr@aol.com
> > Sent: Friday, September 15, 2000 7:25 PM
> > To: Multiple recipients of list proteledausers
> > Subject: [PROTEL EDA USERS]: Default Designators
> > 
> > 
> > I have tried to set the default size of designators in PCB (99SE 
> > sp5), but 
> > any time I import new components from a netlist it always uses 
> > the factory 
> > default of 60 mils height, 10 mils width for all new ref 
> > designators. Am I 
> > missing something or is this just a bug in the package?
> > 
> > Steve Hendrix