|
Installing the servo ¡@ |
||
|
making the main body
making the cyclic control system ¡@ an introduction to electronic components building an airborne video system ¡@ |
¡@ | Only two servos are used in my
design.
One is for the elevator and the other one is for aileron. In my design,
the aileron servo is installed between the motor and the main shift
holding tube. In this way, the tube has made use of the sturdy plastic
case of the servo as one of its supporting medium.
¡@ This arrangement gives extra strength to the main shift holding tube as one side of the servo is glued to the motor while the other side is glued to the tube. However, the mobility of the servo as well as the motor is lost. ¡@ ¡@ ¡@ In order to make the whole structure sturdier, an additional support is added to the main shift holding tube. It is also made from circuit board with some holes drill on it.
¡@
¡@ ¡@ ¡@ ¡@ |
Ben Hui - web master 2002 |
||
¡@
