| Previous | Toc | Next |
NOTE:
Do not use a heavy
hammer blow
as it will dent the
wheel ring. A light
tap
with the hammer and
wood block is sufficient
as shown in figure
163.
Approximate Flat Rate Time .1 of an hour.
986407 SAFETYLIGHT AND MIRROR UNIT
Procedure
for Installation of
Safetylight and Mirror
on All Model Passenger Cars.
Figure 164
Drilling The Door
1.
Select the proper Mounting
Template and
cut out along heavy black lines. Place Tem
plate in exact location on door and hold in
Figure 165
place
with short strips of tape (see figure
165).
2.
Center punch two location holes and drill
with a No. 29 or 9/64" drill. DO NOT TAP
HOLES.
3.
Leaving the paper Template on door (see
figure 165), place Bracket and Gasket over
9/64" holes so that Bracket hub extends
forward, then fasten Bracket securely in
place with oval head sheet metal screws.
Care should be taken to tighten each screw
only a little at a time, until both screws
are tight, to keep the Bracket from creep
ing.
4.
Drill through door with 1/2" drill, prefer
ably of the hole saw type, using the mount
ing bracket as a drill jig. (See figure 166.)
HOLD DRILL IN LINE WITH BRACKET.
FEED DRILL SLOWLY.
Figure 166
| Previous | Toc | Next |
