3. Remove clip and push wire aside on pas
senger side of dash on Power Glide only;
then locate and drill two 17/32 diameter
holes from existing windshield wiper tube
hole. Cut out dash mat. Reassemble clip
and wire, (see figure 218).

Figure 218

4. Clips to be mounted on second garnish
moulding screws from windshield division
strip, (see figure 219). Place clip on tip of
screw. Back screw out until clip touches
instrument panel. Hold clip in this position
and tighten screw.

Figure 219

5. Cut small diameter tube in half and insert
tee fitting furnished in package,(see figures
220 and 232).

Figure 220

fi. Remove Glove Box. Route small diameter
tube through windshield wiper motor mount
ing bracket, through the two special clips
and to the tubes extending down through
wiper pivots. See that washer tube is kept
clear of windshield wiper mechanism, (see
figure 223).

7. Cut the longest large diameter tube in half
and run one piece from fitting located near
est to edge of jar cover, along wiring har
ness and through upper hole previously
drilled in dash. Attach tube to clip and in
stall under dash mat fastener as shown in
figure 221, and connect to tee located under
cowl,(see figure 223).

Figure 221

8.   Run the other piece of tube from the fitting
centered on jar cover along wiring harness
and through lower hole previously drilled in
dash. Connect tube to the long fitting on
windshield wiper control mounted on the in
strument panel,(see figure 228). Put grorn
mets furnished on tubes and insert in hole in
dash,(see figure 223).

9. Clamp four places large diameter tube to
the wiring harness as shown in figure 222.
With clamps furnished.

Figure 222